Standard mains power cord. IEC female connector to Australian mains 3 pin plug fitted on a 3-core power cord. Typically used to power computers, monitors and UPS systems. Required Items This cable is typically used to connect a PC or peripheral to a 240 Volt power point. Features: IEC Plug The IEC (International Electrotechnical Commission) is the international standards and conformity assessment body for all fields of electrotechnology. A set of thirteen plugs (called the connector in the specification) and thirteen matching sockets (called the appliance inlet) are defined by specification IEC 60320. A set of 11 connectors/appliance-inlets are defined in specification AS/NZS 60320.1:2004. The plugs and sockets have either two or three -conductors to suit either Class I or Class II equipment with varying current capacities and temperature ratings. A plug's matching socket is designated by an even number that is one number higher than the odd number assigned to the plug. Therefore, a C13 plug fits into a C14 socket, a C19 plug fits a C20 socket etc. Australian 3-Pin Electrical Mains Plug The domestic mains power supply in Australia is 240V AC, 50Hz. Standard 3-pin earthed power outlets are rated at 10Amps and are usually switched. The 3-flat-pin plug is used in all states of Australia (including its external territories), New Zealand, Papua New Guinea and the Solomon Islands. Although the configuration is similar to mains plugs used in mainland China, dimensional differences to the plug body may be incompatible with recessed cord socket and prevent Chinese-compliant CPCS/CCC (CCEE) plugs from being legally sold/used in Australia. Argentina also uses a similar 3-flat-pin configuration as Australia, but with slight dimensional differences and with the active and neutral wires being reversed. These important differences prevent the Argentina-compliant IRAM plugs from being legally sold/used in Australia as incorrect polarity may present an electrical safety hazard. The Australian mains plug configuration was originally presented as provisional standard C112 in 1937, formalised as Standard C112 in 1938, redesignated AS3112 in 1981 and harmonized with the New Zealand standard and redesignated AS/NZS3112 in 1993. Australian Standards AS/NZS 3112:2000 and AS/NZS3112:2004 for Australian Mains Plugs now define the requirements for the insulation of the Active and Neutral pins of the plug. 15Amp and 20Amp configurations of the mains plug and outlet are also defined by the standard. Specifications: Australian approved 10 Amp rating. Fully Molded cable. 1 x IEC C13 Female (Socket.) 1 x 240 Volt 3 pin Male mains wall plug. Cable is black in colour.